MB Dracula Bracket Fix

Monster Bash
Problem: Playfield Warped at Dracula
On some of the Monster Bash games produced before December 15, 1998, we have
seen that the playfield by the slot where the Dracula slides, may drop or
appear warped. If the ball bounces when shot up the right ramp or right
lane, install bracket 01-15202 per instructions attached.
Order one bracket 01-15202 and two screws 4808-01175-08 for each game that
you feel needs this update.

---------------------------------------
Also, here are the installation instructions.
These were provided by Ron Hansen. Thanks, Ron.

It can really only fit 1 way if you know where to mount it.

Raise the playfield and look to the far right of the dracula slot, where the 
large opening is. This is where the bracket goes, across the opening. You'll 
see 2 nuts already on the machine, 1 on each side of the large opening. You 
remove the nuts and washers. Now simply put the bracket over the 2 studs 
where the nuts were removed. The bracket has an additional large hole that 
fits over a steel obstruction on the board so the bracket is able to lay flat 
on the board. Everything can really fit only 1 way. Now simply reinstall and 
tighten the 2 previously removed nuts and tighten the 2 screws you bought 
into the remaining holes on the bracket. That's it. Takes a couple minutes 
and problem is repaired.